Chemical Engineering December 2017 - 77

Corporate Capabilities Profile Information Page
Exotherm Corporation
Exotherm Corporation
888 Wilcrest Drive
Houston, TX 77042
Phone: 713-981-9100
Fax: 713-981-7081
E-mail: info@exotherm.com
www.exotherm.com
UNIFLUX/EXOTHERM
Exotherm Corporation is a leader in providing custom designed
fired heaters to the chemical processing and oil and gas
processing industries.
CONVECTION
HEAT TRANSFER
Exotherm's Uniflux
Convection Heater was
developed fifty years
ago to overcome the
problems of overheating
and degrading heat
sensitive process fluids that customers experienced with their
existing fired heaters.
The Uniflux Convection Heater is custom designed for processes
requiring 100,000 to 70,000,000 Btu/hr absorbed duty. The heater
is designed to utilize the circulation of high velocity exhaust gases
around the process tubes to produce convective heat transfer. This
heat transfer is uniform around the periphery of the process tubes.
The result is lower tube wall and film temperatures compared with
the radiant heat transfer method used in most heaters.
NO FLAME IMPINGEMENT
The high velocity Uniflux burner has a very short flame extension,
preventing flame impingement on the process tubes. This in turn
reduces tube failure and coking.
EFFICIENCY
The forced draft burner operates at very low excess air. This
feature allows the Uniflux Convection Heater to operate at higher
efficiencies than can be achieved with conventional radiant,
natural draft heaters. Uniflux Convection Heaters equipped with
process pre-heat
economizers can
achieve efficiencies as
high as 95% for some
processes, and the
forced draft design
allows the Uniflux
heater to maintain the
efficiency over the entire
operating range.
CHEMICAL ENGINEERING WWW.CHEMENGONLINE.COM
SAFETY AND RELIABILITY
Each Uniflux Convection Heater is equipped with a field proven
burner management system and safety controls. The heater and
all of its controls are completely shop assembled. The control
system is tested at the factory to ensure safe and reliable operation
when installed.
LOWER INSTALLATION COSTS
The Uniflux Convection Heater is designed as a package and is
completely assembled at the factory. Smaller heaters are shipped
as a complete package. Larger heaters are disassembled into three
major components. This makes installation easy and less costly.
FIELD SERVICE
Qualified, experienced technicians are available to assist
the customer with start-up, operator training, preventative
maintenance programs and trouble shooting.
APPLICATIONS
Uniflux Convection Heaters
are used worldwide in
numerous industries
for a variety of heating
applications. A few are
listed below:
Heat Transfer Fluids
Cryogenic fluids
LNG Liquefaction &
Vaporization
Regeneration Gas
Crude Oil
Natural Gas Processing
Glycol-water
Emulsions
Offshore Production Processing
Air & Nitrogen
Vaporizers
Specialty Chemical Processes
OTHER PRODUCTS
Exotherm Forced Draft Water Bath Heaters, Q-PAK Direct Fired Air
Heaters, and Heat Media Circulation Systems.
DECEMBER 2017
77
TURNDOWN
The normal turndown
ratio of the Uniflux
Convection Heater is
10:1. Turndown ratios
of 40:1 can be achieved
with custom designed
burner controls.
http://www.exotherm.com http://WWW.CHEMENGONLINE.COM
Chemical Engineering December 2017

Table of Contents for the Digital Edition of Chemical Engineering December 2017
