Instrumentation & Measurement Magazine 26-4 - 18

instrumentationand
measurementsystems continued
Hanna Müller, Weikang Kong, Yuriy Marykovskiy, and Gregory
Duthé for their valuable support.
References
[1] M. N. S. Suryakiran, W. Begum, R. S. Sudhakar and S. K.
Tiwari, " Development of wind energy technologies and their
impact on environment: a review, " Advances in Smart Grid
Technology, P. Siano and K. Jamuna, Eds. Singapore: Springer,
pp. 51-62, 2020.
[2] L. Yang and Z. Zhang, " Wind turbine gearbox failure detection
based on SCADA data: a deep learning-based approach, " IEEE
Trans. Instrum. Meas., vol. 70, no. 3507911, pp. 1-11, 2020.
[3] Y. Peng, W. Qiao, F. Cheng, and L. Qu, " Wind turbine drivetrain
gearbox fault diagnosis using information fusion on vibration
and current signals, " IEEE Trans. Instrum. Meas., vol. 70, no.
3518011, pp. 1-11, 2021.
[4] F. Bilendo, H. Badihi, N. Lu, P. Cambron, and B. Jiang, " A normal
behavior model based on power curve and stacked regressions
for condition monitoring of wind turbines, " IEEE Trans. Instrum.
Meas., vol. 71, pp. 1-13, 2022.
[5] Z. Liu, X. Wang, and L. Zhang, " Fault diagnosis of industrial
wind turbine blade bearing using acoustic emission analysis, "
IEEE Trans. Instrum. Meas., vol. 69, no. 9, pp. 6630-6639, 2020.
[6] J. Deparday, H. Müller, T. Polonelli, and S. Barber, " An
experimental system to acquire aeroacoustic properties on wind
turbine blades, " J. Physics: Conf. Series, vol. 2265, no. 2, May, 2022.
[7] S. Barber, J. Deparday et al., " Development of a wireless, nonintrusive,
MEMS-based pressure and acoustic measurement
system for large-scale operating wind turbine blades, " Wind
Energy Science, vol. 7, no. 4, pp. 1383-1398, 2022.
[8] P. Veers, K. Dykes et al., " Grand challenges in the science of wind
energy, " Science, vol. 366, no. 6464, 2019.
[9] H. Badihi, Y. Zhang, B. Jiang, P. Pillay, and S. Rakheja, " A
comprehensive review on signal-based and model-based
condition monitoring of wind turbines: fault diagnosis and
lifetime prognosis, " in Proc. IEEE,110(6): 754-806.Setiyadi, S.,
Mukhtar, H., & Cahyadi, W. A. (2021, August). 2022
[10] T. Polonelli, H. Müller, W. Kong, R. Fischer, L. Benini, and M.
Magno, " Aerosense: a self-sustainable and long-range bluetooth
wireless sensor node for aerodynamic and aeroacoustic
monitoring on wind turbines, " IEEE Sensors J., vol. 23, no. 1, pp.
715-723, 2022.
[11] S. Setiyadi, H. Mukhtar and W. A. Cahyadi, " A comparative study
of affordable photogrammetry software for reconstructing 3D
model of a human foot, " in Proc. 2021 IEEE 7th Int. Conf. Smart
Instrum. Meas. Applications (ICSIMA), pp. 286-291, 2021.
Tommaso Polonelli (M'20) (tommaso.polonelli@pbl.ee.ethz.
ch) is a Post-Doctoral Researcher at ETH Zürich in Zürich,
Switzerland. He received the Ph.D. degree in electronics engineering
from the University of Bologna, Bologna, Italy in
2020. His research work focuses on wireless sensor networks,
IoT, autonomous unmanned vehicles, and structural health
monitoring.
Julien Deparday (julien.deparday@ost.ch) is a Researcher at
the Wind Energy Innovation Division in the Eastern Switzerland
University of Applied Sciences, Rapperswil-Jona,
Switzerland. He obtained the Ph.D. degree from the Research
Institute of the French Naval Academy, Brest, France
in 2016. His research focus is on experimental fluid dynamics
and on field measurements and unsteady aerodynamics.
Imad Abdallah (abdallah@ibk.baug.ethz.ch) is a Senior Scientist
in the Structural Mechanics and Monitoring Department
of Civil, Environmental and Geomatic Engineering of ETH
Zurich, Switzerland. He carried out his Ph.D. thesis research
on the " Assessment of extreme design loads for modern wind
turbines using the probabilistic approach " at the Technical
University of Denmark in Lyngby, Denmark.
Sarah Barber (sarah.barber@ost.ch) is Head of the Wind Energy
Innovation Division at the Eastern Switzerland University of Applied
Sciences, Rapperswil-Jona, Switzerland. She is a Lecturer in
wind energy at the Universities of St. Gallen and Graubünden.
Eleni Chatzi (echatzi@ethz.ch) is the Chair of the Structural Mechanics
and Monitoring Department at ETH Zürich, Switzerland.
She has obtained a Ph.D. degree with distinction from the Civil
Engineering and Engineering Mechanics Department at Columbia
University in New York, NY, USA in 2010. Her research focus
on structural health monitoring and data driven simulations.
Michele Magno (S'13) (michele.magno@pbl.ee.ethz.ch) is a Senior
Scientist at ETH Zürich, Switzerland in the Department
of Information Technology and Electrical Engineering. He received
his Ph.D. degree in electronic engineering from the
University of Bologna, Italy in 2010.
18
IEEE Instrumentation & Measurement Magazine
June 2023
Instrumentation & Measurement Magazine 26-4

Table of Contents for the Digital Edition of Instrumentation & Measurement Magazine 26-4
