Eclipse Laboratory Grade Steel Furniture - 26

LD-4 Adaptable Laboratory Tables

Table Top Materials

Trespa® (Phenolic Resin)
The Trespa TopLab countertop is ideal for multi-purpose laboratories.
Because of the countertop's unique properties, including chemical and
bacterial resistance, the Trespa can be utilized in analytical, microbial
or chemical labs. Combined with these unique attributes, the Trespa
TopLab countertop's excellent physical and mechanical properties provide
strength, toughness and durability to insure many years of useful service.

Stainless steel work surfaces offer a practical solution for high moisture
areas, infection control considerations, radioisotope work and/or areas
that are subject to fire and high abrasion. Stainless steel work surfaces are
made from 16-gauge type 304 stainless steel with #3 finish. The underside
of the work surfaces is reinforced with steel channels and covered with
sound deadening material. All exposed welding is ground smooth and
polished to match a No. 4 satin finish.

Standard Laminate

Epoxy Resin
Epoxy resin is the table top choice for harsh laboratory, classroom and
research environments because of the material's outstanding chemical
resistance, durability, non-flammability, and non-absorbency

IAC uses only high pressure postforming horizontal grade laminates.
All laminates are comply with federal specifications governing impact,
abrasion and chemical resistance (FED Spec-L-P-508H).

ESD Laminate

Chemsurf® - Chemical Resistant Laminate
Chemsurf® Chemical-Resistant Laminate is produced for work tops
and cabinet surfacing in intermediate-type laboratories where weight or
cost constraints rule out slate, epoxy or stainless steel; the possibility of
chemical spills rules out conventional high-pressure decorative laminate;
or where a trend-aware colored or patterned surface is desired. Chemsurf
is also recommended in areas where indiscriminate use of a variety of
cleaning agents may be used.

Resistant measurements are used to establish the charge draining
capacity of dissipative hard laminate. All table tops are tested for resistivity.
Surface to ground testing R (ohms): 1x106 minimum 1x109 maximum.
Surface to surface testing R (ohms): 1x106 minimum 1x109 maximum.

Stainless Steel

Standard Electrical System - LAB (SES-LAB) Electrical
██
██

SES-L - Standard Electrical System LAB
Best suited for stand-alone applications.
*	 Also suited for in-line applications with a separate power source for
each station

██

Integrates power into the workstation.

██

Supplies additional outlets located in the uprights.

██

Single 15 Amp, 120VAC circuit.

██

Each workstation will have 6 outlets located on the inside trim
panel of each upright.
*	 Same for single sided and double sided applications
*	 Available on 60˝, 72˝, and 84˝ uprights

██

Electrical is pigtailed allowing power to be pulled from the top
of the upright or from the bottom of the upright or underneath
the upright.

██

When using in-line bench configurations:

84˝

*	 Adder upright has outlets on both sides
*	 Each side of adder upright is NOT connected to the other side

72˝

██

Duplex configured outlets are not flush with the trim panel.

██

Duplexes may affect location of accessories.

██

Accent/Trim panel is metal.

37˝

labs.iacindustries.com

37˝

60˝

37˝

26
http://labs.iacindustries.com
Eclipse Laboratory Grade Steel Furniture

Table of Contents for the Digital Edition of Eclipse Laboratory Grade Steel Furniture
