AUTOMATED TEST You can test for voltage dips (pops) & short interruptions with the following steps: That's it for setting. After that, just turn on the output and run the simulation. With the above contents, the output waveform when simulation is performed is as follows: 1. Set the voltage and frequency before voltage dip [VSET] 2. Set the dip start time (or angle) [T1] 3. Set the time taken for the dip [T2] 4. Set the dip voltage [V(T3)] 5. Set the dip time [T3] 6. Sets the time it takes to pop [T4] The easy programming 7. Set the interval time [T5] It is possible to test while increasing the dip time manually, but because it takes time, create a simple program using Python and automate it. All of the above settings can be made using 8. Set the number of repetitions [LOOP] 26 EVALUATION ENGINEERING NOVEMBER 2019http://www.rsleads.com/911ee-903