Fleet Maintenance - 49

F E AT U R E D
PRODUCT

Designed for all-season traction

Offers a small footprint
The Coats 885 Wheel Balancer is designed for
low-volume, occasional balancing of OE fitments. The
885 offers a small footprint, allowing it to fit almost
anywhere. This gives technicians the flexibility to finetune their workflow process as they grow. The wheel
balancer uses audible beeps to indicate the exact
placement of Tape-A-Weights and takes the guesswork out of behind-the-spoke balances. When the
885's protective hood is lowered, it starts the balancing process and offers additional protection.
For more information visit VehicleServicePros.com/21114408

The Michelin X MULTI D Pre-Mold Retread is a
regional drive retread designed for all-season
traction without compromising high mileage
to provide optimal total cost of ownership and
driver satisfaction. The retread features an open
shoulder design with regenerating tread technologies for optimum grip throughout life, as well as
28/32nds of tread with compounding designed
to deliver scrub resistance and high mileage. The
co-extruded compounding is designed to reduce
heat build-up, therefore, protecting the casing
and improving fuel efficiency. Additionally,
teardrop grooves at the base of the sipes are
designed to provide reduced stress under high
torque conditions.
For more information visit VehicleServicePros.com/21150925

www.michelintruck.com

For U-Pro Hybrid 2.0 sensors
The Hamaton Gun Metal Grey Clamp-In Valve is for use
with Hamaton's U-Pro Hybrid 2.0 sensor and is designed
to possess the same features and benefits as its alloy and
black counterparts. The TPMS valve features an anodized
coating to prevent corrosion from chemicals and road salt
in winter. Its washer enables users to tighten the valve
without scratching the alloy wheel surface and its nut-overcap feature allows users to remove/attach the nut while
the cap is on, reducing the time it takes to fit a sensor to a
wheel, the company says.
For more information visit VehicleServicePros.com/21110918

Improves safety while
working on large tires
The Branick Industries Tire Safety
Cage, No. 2264, is designed for
working on large tires. The 2264 will
hold tires up to 29" wide and 59" in
diameter. Its strapped, six bar design
with slotted side panels helps keep
both large and small debris contained
in the event of a tire failure. Side
pass-through ports allow the tire
technician to remain protected while
attaching an air hose. All Branick safety cages meet OSHA standards and
are made in the U.S.A.

For more information visit
VehicleServicePros.com/21045261
VehicleServicePros.com/10122353

September 2020 | VehicleServicePros.com

http://www.VehicleServicePros.com/21150925 http://www.michelintruck.com http://www.VehicleServicePros.com/21114408 http://www.VehicleServicePros.com/21110918 http://www.tireindustry.org http://www.VehicleServicePros.com/21045261 http://www.VehicleServicePros.com/10122353 http://www.VehicleServicePros.com

Fleet Maintenance

Table of Contents for the Digital Edition of Fleet Maintenance