14.4 INSTALLATION OF FDT 7.0 / FDT 4.5 GRIPWALK 14.4 - 6 INSTALLING THE HEEL: * Open the heel locking lever and slide the heel onto the plate starting from the center. (14.4 - 6 & 14.4 - 7) * Slide the heel backward. (14.4 - 8) 14.4 - 7 CAUTION ! Ensure that the rails of the heel engage both sides of the base plate properly. * Slide the heel to the correct sole length in accordance with the rear sole length scale. (14.4 - 9) * Close the heel locking lever. (14.4 - 10) 14.4 - 8 CHECK FORWARD PRESSURE: 14.4- 9 * Place the ski boot into the binding, close the binding. * Correct forward pressure: With the boot in the system the forward pressure indicator on the locking lever has to point to the marked section on the side of the heel housing. (14.4 - 11) If the forward pressure is incorrect: remove the ski boot, lift the lever and move the heel until the forward pressure is correct. 14.4 - 10 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 REMARK: ADJUSTMENT OF DEMO BINDING MODELS: also refer to chapter 14.5 14.4 - 11 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 100 14.4 MARKER RENTAL & DEMO MODELS