16.3 INSTALLATION OF MARKER KINGPIN DEMO BINDINGS 16.3 - 5 a * Close the locking lever. (16.3 - 5 a) CAUTION ! Ensure that the lever is engaged properly ! Visually check locking mechanism: when locking the system the opening lever has to snap into the basic position. The warning symbol must not be visible ! (16.3 - 5 b) 16.3 - 5 b INSTALLING THE HEEL PLATE: * Install the heel plate with the pre - installed screws in the rear holes. * Tighten the screws lightly, then firmly. (16.3 - 6) 16.3 - 6 INSTALLING THE HEEL: * Slide the heel from the rear of the plate forward until it stops. (16.3 - 7) * With strong pressure, screw the heel forward onto the plate by turning the forward pressure adjustment screw. (16.3 - 8) 16.3 - 7 CAUTION ! Screw the heel onto the heel plate by hand ! 16.3 - 8 * Open the toe by pressing down the toe opening lever. (16.3 - 9) * Switch the change-over lever 180° forward. (16.3 - 10) 16.3 - 9 16.3 - 10 180 ° 121 16.3 INSTALLATION OF MARKER KINGPIN DEMO BINDINGS