16.8 DIN ADAPTER AT BOOT DIN - ADAPTER AT BOOT FOR DYNAFIT TLT 5 + TLT 6 BOOTS FOR ATOMIC BACKLAND BOOTS A001P1D IMPORTANT ! 16.8 - 1 The Marker DIN Adapter can only be used on specific AT boots (Dynafit TLT 5, Dynafit TLT 6 and Atomic Backland models). These boot models are not compliant with the dimensions of the ISO AT Bootsole (ISO 9523). Adding the Marker DIN Adapter to these specific boot models will allow them to properly function with the Marker Kingpin Bindings. IMPORTANT ! Tools required for assembly: DIN Adapter, Power drill, 16.8 - 2 Drill bit size 2mm, small slotted screwdriver, Phillips head screwdriver size PH2, Torx screwdriver size 10 (16.8 - 1) * Use the Phillips head screwdriver to unscrew the screw with which the heel insert is fixed in place. (16.8 - 2) 16.8 - 3 * Then remove the heel insert. This can be gently levered out using a small slotted screwdriver. (16.8 - 3 and 16.8 - 4) 16.8 - 4 132 16.8 DIN ADAPTER AT BOOT