17.3 INSTALLATION OF MARKER ALPINIST DEMO BINDINGS * Adjust the lateral release force. (17.3 - 20) 17.3 - 20 Z = 17.3 - 21 CAUTION: IMPORTANT INFORMATION FOR THE SKIER! Explain that MARKER ALPINIST ski bindings do not meet any ISO Certification and therefore the release function does not need to be tested to verify function release. Show where the release adjustment screw is located and explain the visual indicators on the binding and how they do not directly correlate to the initial indicator values on the adjustment chart, but serve as a good starting point for binding setup. Explain the U-BOW (Spring) is a fixed verticle release force and can be changed to achieve the skiers preferred vertical release. Advise the skier as to the correct U-BOW (Spring) per their release/retention preference. The initial indicator values should be used as a starting point for the binding setting process and may need to be modified in order for the skier to achieve correct retention preference. 17.3 - 22 B A CAUTION ! The lateral release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 NOTE: 17.3 - 23 When mounting the binding make sure that you fit the enclosed stickers (brake) to the ski. (17.3 - 21) * Changing the brake over from descent to ascent position: Slide the brake lever forward until you feel it lock in place. The brake is engaged by hand by pushing the brake pedal down or by stepping down on the pedal when stepping in. (17.3 - 22) 17.3 - 24 * Changing the brake over from ascent to descent position: To disengage the brake, push the brake lever backward until you feel it lock in place. (17.3 - 23) NOTE: When mounting the binding make sure that you fit the enclosed stickers (toe) to the ski. (17.3 - 24) 144 17.3 INSTALLATION OF MARKER ALPINIST DEMO BINDINGS