3.2 TOOLS AND THEIR APPLICATION: 3.2 - 1 3 1 2 2 1 ADJUSTMENT OF THE BINDING INSTALLATION TOOLS IMPORTANT ! Use only original MARKER installation tools ! Make sure that the installation tool is correctly positioned on the ski for all adjustments ! REMARK: The following installation steps are basic know - how and valid for all MARKER bindings. 4 5 ADJUSTING BOOT SOLE LENGTH OPTIMIZED BY USING THE SKI BOOT: (3.2 - 1) * Twist the grips (1) until the clamping jaws (2) are fully extended. Position the installation tool on the ski and lock it by releasing the grips. * Open the locking lever (3) and place the boot heel against the heel guide (5). 3.2 - 2 6 * Slide the toe guide (4) until the boot is firmly against both toe (4) and heel guide (5). * Check that boot's mid boot mark is aligned with mid boot mark on installation tool (6). (3.2 - 2) * Close the locking lever (3). * Remove the ski boot. 3.2 - 3 DETERMINE THE BINDING PLACEMENT ON THE SKI IF MID - SOLE MARKS ON THE SKIS ARE USED: * Place the installation tool on the ski and align the mid - sole mark on the ski with the mid - sole mark on the installation tool. (3.2 - 3) 3.2 - 4 IF BOOT TOE MARKS ON THE SKIS ARE USED: * Place the installation tool on the ski and align the toe guide on the tool with the boot toe mark on the ski. (3.2 - 4) 3.2 - 5 IMPORTANT ! Before drilling, check that the installation tool is flush and centered on the ski. (3.2 - 5) Take particular care with skis that have angled sidewalls, extreme sidecuts or external plates. 19 3.2 INSTALLATION - GENERAL GUIDELINES