3.2 TOOLS AND THEIR APPLICATION: 3.2 - 7 Drill bits for adult bindings GENERAL INFORMATION INSTALLATION DRILLING: REMARK: 9,5 Use original MARKER drill bits for an optimal result (3.2 - 7). 9,5 3.2 - 7 Drill bits for child & junior bindings * Drill all necessary mounting holes through the drill bushings on the installation tool. (Details: see installation of the individual bindings) * After drilling is completed remove the installation tool from the ski. * Always keep the drill bit vertically aligned with the drill bushings in the installation tool and drill to the countersunk depth. (3.2 - 8) 7,5 * Shavings and dust have to be removed from the surface of the ski and all holes. 7,5 3.2 - 8 TAPPING: REMARK: Holes should only be tapped if recommended by the ski manufacturer. Use an original MARKER tap. Use the installation tool for tapping. * Drill all mounting holes. * Tap through the drill bushings of the installation tool. * Apply slight downward pressure and turn the tap. As soon as the 3.2 - 9 tap begins to cut, simple turning will thread the hole. Turn the tap three or four revolutions. (3.2 - 9) 3 - 4 U> 4 U IMPORTANT ! Be careful not to tap too deep ! * Back the tap out of the hole. Shavings and dust have to be removed from the surface of the ski and all holes. 20 3.2 INSTALLATION - GENERAL GUIDELINES Ø 4,1 Ø 3,6 Ø 4,1 Ø 3,6