3.2 TOOLS AND THEIR APPLICATION: 3.2 - 10 ATTACHMENT SCREWS: IMPORTANT ! Use only original MARKER attachment screws. * All screws must be firmly seated and not stripped. * If a power driver is used, keep the torque settings on the clutch as low as possible to help prevent stripping of the screws. * Final tightening of the screws must always be done by hand. * The screw head should be flush with the binding and the binding should be firmly attached to the ski. * Check that each screw is firmly seated. REMARK: For supply or to check for the correct screws use the SCREW CHARTS 18.1 3.2 - 11 STRIPPED SCREWS: Occasionally a screw will be over - torqued or the hole stripped. Repair using: MARKER hollow drill bit (Part No. 2651) MARKER helicoil insert (Part No. 2653) * Remove all binding parts from the ski. * Place the proper installation tool over the stripped holes to use the appropriate drill bushing to repair the stripped screw. * Slowly drill through the bushing until the hollow drill bit step stops on the top of the bushing (3.2 - 10). 3.2 - 12 * Remove the installation tool. * Shavings and dust have to be removed from the surface of the ski and all holes. Strike the base with your hand to remove any shavings. * Using a hammer, plug the hole with the MARKER plastic insert (3.2 - 11). CAUTION ! Make sure that the plastic insert is flush with the top - sheet of the ski (3.2 - 12) ! * Re - install the binding. CAUTION ! Insert the binding screws and tighten only by hand ! 21 3.2 INSTALLATION - GENERAL GUIDELINES