4.3 MARKER DUKE PT - INFORMATION FOR THE SKIER 4.3 - 1 In addition to the system explanations 15.1 - 15.4, the following instructions must be given to the intended user of a MARKER DUKE PT binding: IMPORTANT ! The DUKE PT's ascent function can only be used with boots with Tech inserts. 4.3 - 2 CHANGE OVER FROM SKIING TO HIKING POSITION * There is an adjusting lever at the front end of the toe. To switch from the descent position to ascent mode in order to walk with the binding, step out of the binding, push the adjustment lever down with your hand or ski pole and unlock toe " Ski " (4.3 - 1). * Fold toe " Ski " forward until it rests on the ski surface and engages (4.3 - 2). 4.3 - 3 A B IMPORTANT ! 4.3 - 4 The DUKE PT binding model has removable parts (toe " Ski " ), which are absolutely necessary for a descent with the binding. Therefore, make sure that you store these parts securely so they cannot be lost after you have removed them. * For longer ascents, toe " Ski " can be removed by lifting the locking plate and pulling toe " Ski " forward from toe B " Walk " (4.3 - 3). * Clear snow, ice and dirt from the sole of your ski boot and the Tech inserts before stepping into the binding. 4.3 - 5 * Position the tip of the ski boot between the pins on the toe. Then press the tip of the boot down and step into the toe until the pins are locked fully into position in the insert (4.3 - 4). * To lock the toe pull the toe lever upwards (4.3 - 5). Move the locked boot back and forth several times to ensure that boot and binding are securely connected. 4.3 - 6 CHANGING THE BRAKE OVER FROM DESCENT TO ASCENT POSITION * Swivel the brake locking lever upwards as far as it will go (4.3 - 6). 28 4.3 MARKER DUKE PT - INFORMATION FOR THE SKIER