5.4 INSTALLATION OF MARKER JESTER PRO ID & JESTER ID & GRIFFON ID 5.4 - 1 REMARK: heel ( 18.3) toe 5.4 - 2 See ADJUSTMENT OF THE BINDING INSTALLATION TOOLS 3.2 * Place the MARKER universal installation tool W001G1T or W012J1T (5.4 - 1) in the correct position on the ski. * Drill 4 holes for the front plate (toe) through the red marked drill bushings. SKI TIP 5.4 - 3 * Drill 4 holes for the heel plate (heel) through the red marked drill bushings * Remove installation tool from the ski. REMARK: See DRILLING INSTRUCTIONS 3.2 INSTALLING THE HEEL : * Install the heel plate with the 4 pre - installed screws (5.4 - 2). Tighten the screws lightly, then firmly. * Slide the heel onto the heel plate, starting from the front. (5.4 - 3) 5.4 - 4 * Slide the heel back until it stops. (5.4 - 3) CAUTION ! Ensure that the heel is fully and uniformly sliding onto the heel plate. (5.4 - 4) The binding models " sole.ID " are designed for the following standard boot soles: * Touring ski boots for adults ISO 9523 * Alpine ski boots for adults ISO 5355 * Touring ski boots for adults ISO 9523 with the additional marking " Gripwalk® " DRILLING THE ATTACHMENT HOLES: 42 5.4 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS