5.4 INSTALLATION OF MARKER JESTER PRO ID & JESTER ID & GRIFFON ID 5.4 - 11 ISO 9523 TOURING * When the gliding AFD is adjusted to the front / lower position, the height conforms to the ISO 9523 (Touring boots) (5.4 - 11) REMARK: 5.4 - 12 When mounting the toe to the height adjustment " touring " make sure that you fit the enclosed " Touring " indication sticker to the ski. POSITIONING THE HEEL: * Move the heel backwards by turning the forward pressure adjustment screw. * Place the ski boot into the binding. Move the heel backwards until the position of the heel is approximately right. (5.4 - 12). 5.4 - 13 CHECK FORWARD PRESSURE: * Place the ski boot into the binding and close it. (5.4 - 13) 5.2 - 14 * Check if the forward pressure adjustment screw is flush with the back of the heel housing. If this adjustment is incorrect, turn the screw until it is flush with the back of the housing. (5.4 - 14) * Remove the ski boot. 5.4 - 15 Turning the adjustment screw clockwise moves the AFD gliding plate down. Turning the adjustment screw counterclockwise moves the AFD gliding plate up. * Place the height test strip on the gliding AFD with the red marked side up. (5.4 - 15). 5.4 - 16 * Place the ski boot into the binding and close it. (5.4 - 16) 44 5.4 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS