5.4 INSTALLATION OF MARKER JESTER PRO ID & JESTER ID & GRIFFON ID 5.4 - 17 * Pull out the lower part of the test strip carefully. (5.4 - 17) 5.4 - 18 * Stop if the complete test strip moves and the red marked area becomes visible, the gap between gliding AFD and boot sole is not correct. (5.4 - 18) 5.4 - 19 * Adjust the height of the gliding AFD by turning the adjustment screw (5.4 - 19) so that you can pull out the green marked lower part of the test strip just before it tears (5.4 - 20 and 5.4 - 21). 5.4 - 20 CHECK FORWARD PRESSURE: * Place the ski boot into the binding and close it. * Check if the forward pressure adjustment screw is flush with the back of the heel housing. If this adjustment is incorrect, turn the screw until it is flush with the back of the housing (5.4 - 22). * Remove the ski boot, then re - insert it into the binding and recheck the adjustment. 5.4 - 21 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 CAUTION ! 5.4 - 22 The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 45 5.4 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS