5.6 INSTALLATION OF SQUIRE 10 MODELS 5.6 - 1 REMARK: ( 18.3) toe The binding model Squire 10 is designed for the following standard boot soles: * Alpine ski boots for adults ISO 5355 * Touring ski boots for adults ISO 9523 with the additional marking " Gripwalk® " heel DRILLING THE ATTACHMENT HOLES: See ADJUSTMENT OF THE INSTALLATION TOOLS. 3.2 5.6 - 2 * Place the MARKER universal installation tool W001G1T or W012J1T (5.6 - 1) in the correct position on the ski. max. 4 Nm * Drill 4 holes for the front plate (toe) through the red marked drill bushings. * Drill 4 holes for the heel plate (heel) through the green marked drill bushings. * Remove installation tool from the ski. REMARK: See DRILLING INSTRUCTIONS 3.2 5.6- 3 INSTALLING THE TOE: * Install the front plate with the pre - installed screws in the front holes. Tighten the screws lightly, then firmly (5.6 - 2). * Slide the toe onto the front plate from the rear (5.6 - 3). 48 5.6 INSTALLATION OF MARKER ROYAL FAMILY BINDINGS