8.1 INSTALLATION OF rMOTION2 GRIPWALK MODELS 8.1 - 6 INSTALLING THE HEEL: * Slide the heel from the rear of the plate forward until it stops (8.1 - 6). * With slight pressure, screw the heel forward onto the plate by turning the forward pressure adjustment screw (8.1 - 7). 8.1 - 7 CAUTION ! Ensure that the heel is fully and uniformly sliding onto the plate (8.1 - 8). 8.1 - 8 SOLE LENGTH ADJUSTMENT: * Screw the heel to the correct sole length in accordance with the sole length scale (8.1 - 9). IMPORTANT SAFETY ADVICE ! Make sure that you do not exceed the »STOP« marking on the plate when adjusting the sole length backward ! (8.1 - 10) 8.1 - 9 CHECK FORWARD PRESSURE: * Place the ski boot into the binding, close the binding. * Check if the forward pressure adjustment screw is flush with the back of the heel housing. (8.1 - 11). If this adjustment is incorrect, turn the screw until it is flush with the back of the housing. * Remove the ski boot, then re - insert it into the binding and recheck the adjustment. 8.1 - 10 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 Ls 260 - 370 REMARK: 8.1 - 11 ADJUSTMENT OF DEMO BINDING MODELS: also refer to chapter 14.5 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 60 8.1 INSTALLATION OF MARKER / VÖLKL SYSTEMS