8.2 WIDERIDE XL TCX DEMO GRIPWALK 8.2 - 8 SOLE LENGTH ADJUSTMENT: * Adjust the sole length either by hand by shifting the binding to the corresponding markings on the scale or by turning the sole length adjustment screw with the appropriate screwdriver. (Use a Pozidriv® 3 screwdriver) (8.2 - 8 and 8.2 - 9) 8.2 - 9 * Lock the system by closing the sole length fixation lever. (8.2 - 10) CAUTION ! The sole length fixation lever must not be pressed down with effort, but is correctly aligned with the locking teeth when it closes easily. 8.2 - 10 CAUTION ! Visually check locking mechanism: when locking the system the opening lever has to snap into the basic position. (8.2 - 11) The warning symbol on the right side of the opening lever must not be visible ! (8.2 - 12) CHECK FORWARD PRESSURE: 8.2 - 11 * Place the ski boot into the binding and close it. * Correct forward pressure: With the boot in the system the forward pressure is correct when any portion of the white scribe mark on the forward pressure indicator is flush with the back edge of the heel housing. (8.2 - 13). If the forward pressure is incorrect: remove the ski boot and readjust the boot sole length until the forward pressure is correct. 8.2 - 12 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 REMARK: 8.2 - 13 ADJUSTMENT OF DEMO BINDING MODELS: also refer to chapter 14.5 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 62 8.2 INSTALLATION OF MARKER / VÖLKL SYSTEMS