8.3 INSTALLATION OF LOWRIDE XL FR DEMO GW INSTALLING THE HEEL: 8.3 - 5 * Open the heel locking lever and slide the heel onto the ski rails from the rear. (8.3 - 5) * Slide the heel forward. (8.3 - 6) CAUTION ! Ensure that the rails of the heel engage both sides of the ski rails properly. 8.3 - 6 * Slide the heel to the correct sole length in accordance with the rear sole length scale. (8.3 - 7) * Close the heel locking lever. (8.3 - 8) 8.3 - 7 CHECK FORWARD PRESSURE: * Place the ski boot into the binding, close the binding. * Correct forward pressure: With the boot in the system the forward pressure is correct when the imprinted line on the forward pressure indicator is visible in the cutout of the heel housing. (8.3 - 9) If the forward pressure indicator line is not visible: remove the ski boot and readjust the boot sole length until the forward pressure indicator line is visible in the cutout. 8.3 - 8 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 REMARK: 8.3 - 9 ADJUSTMENT OF DEMO BINDING MODELS: also refer to chapter 14.5 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 64 8.3 INSTALLATION OF MARKER / VÖLKL SYSTEMS