10.2 INSTALLATION OF MARKER / NORDICA RACE XCELL GRIPWALK 10.2 - 1 REMARK: ( 18.3) Race XCELL GRIPWALK models are designed for the following standard boot soles: toe * Alpine ski boots for adults ISO 5355 * Touring ski boots for adults ISO 9523 with the additional marking " Gripwalk® " heel DRILLING THE ATTACHMENT HOLES: See ADJUSTMENT OF THE INSTALLATION TOOLS. 3.2 10.2 - 2 max. 4 Nm * Place the MARKER universal installation tool W001G1T (10.2 - 1) in the correct position on the ski. * Drill 4 holes for the front plate (toe) through the red marked drill bushings. * Drill 4 holes for the heel plate (heel) through the green marked drill bushings. * Remove installation tool from the ski. REMARK: See DRILLING INSTRUCTIONS 3.2 10.2 - 3 INSTALLING THE TOE: * Install the front plate with the pre - installed screws in the front holes. Tighten the screws by hand with a maximum torque of 4.0 Nm (10.2 - 2). * Slide the toe onto the front plate from the rear (10.2 - 3). 75 10.2 INSTALLATION OF MARKER / NORDICA SYSTEMS