10.2 INSTALLATION OF MARKER / NORDICA RACE XCELL GRIPWALK 10.2 - 4 CAUTION ! Ensure that the toe is fully and uniformly sliding into the front plate attachments (10.2 - 4). * Install the toe with the pre - mounted screws. Tighten the screws lightly, then firmly (10.2 - 5). 10.2 - 5 INSTALLING THE HEEL: * Place the heel with the pre - installed screws onto the ski. * With downward pressure, tighten the screws lightly, then firmly. (10.2 - 6) CHECK FORWARD PRESSURE: * Place the ski boot into the binding and close it. * Check if the forward pressure adjustment screw is flush with the back of the heel housing. (10.2 - 7) If this adjustment is incorrect, turn the screw until it is flush with the back of the housing. 10.2 - 6 * Remove the ski boot, then re - insert it into the binding and recheck the adjustment. CAUTION ! Make sure that you do not exceed the back stop when adjusting the sole length backward ! 10.2 - 7 RELEASE VALUE SELECTION AND ADJUSTMENT: * Following the correct adjustment for sole length and forward pressure, the release value has to be selected and adjusted. Use the weight method to match the individual skier's needs. See RELEASE VALUE SELECTION AND ADJUSTMENT: 12.1 - 12.3 CAUTION ! The release value selection and adjustment has to be done very accurately to care for the skier´s safety. All key information including the release value must be recorded in the workorder. 15.3 76 10.2 INSTALLATION OF MARKER / NORDICA SYSTEMS