14.3 INSTALLATION OF 7.0 RTL / 4.5 RTL GRIPWALK 14.3 - 1 toe heel REMARK: The binding models 7.0 RTL & 4.5 RTL GRIPWALK are designed for the following boot soles: * Alpine ski boots for adults ISO 5355 type A * Junior ski boots ISO 5355 type C * Junior ski boots with the additional marking " GRIPWALK Junior " * Touring ski boots for adults ISO 9523 with the additional marking " Gripwalk® " 14.3 - 2 IMPORTANT ! 4.5 RTL and 7.0 RTL (with length scales 44 - 59 and 54 - 69) have to be mounted with the installation tool W007H1T (14.3 - 1) ! A 14.3 - 3 Center Child - RTL DRILLING THE ATTACHMENT HOLES: * Adjusting the installation tool (W007H1T) for 4.5 RTL: Open the locking lever. Move the toe guide until the marking sticker on the toe guide is aligned with the marking »A« on the frame of the installation tool. Fix the position by inserting a drill bit to the position »A« hole. Close the locking lever, remove the drill bit. Place the pre - installed installation tool onto the ski and align the mid - sole mark „boot center Child - RTL " with the mid - sole mark on the ski. (14.3 - 2) B 14.3 - 4 boot center Junior - RTL Adjusting the installation tool (W007H1T) for 7.0 RTL: Open the locking lever. Move the toe guide until the marking sticker on the toe guide is aligned with the marking »B« on the frame of the installation tool. Fix the position by inserting a drill bit to the position »B« hole. Close the locking lever, remove the drill bit. Place the pre - installed installation tool onto the ski and align the mid - sole mark „boot center Junior - RTL " with the mid - sole mark on the ski. (14.3 - 3) * Drill 3 holes for the toe through the front bushings and 4 holes for the heel through the grey marked rear drill bushings. * Remove installation tool from the ski. REMARK: See DRILLING INSTRUCTIONS 3.2 INSTALLING THE TOE: * Place the toe with the pre - installed screws onto the ski. * Tighten the screws lightly, then firmly. (14.3 - 4) 97 14.3 MARKER RENTAL & DEMO MODELS