STEP 2 STEP 1 Start by making a top and bottom base with 2-in. tape. STEP 3 Add the vertical pieces and lay them directly on the edge of each obstacle you are going to trace. STEP 4 Add smaller pieces of tape until you have the entire shape outlined with blue tape. It's like making a cast template around the obstacle you need to trace. Remove the template and take it to the table. Apply it to your vinyl once you have the exact area where the template will go on your wrap. STEP 6 STEP 5 Use a grease pencil to trace the template onto the wrap. Remove the template and cut it out about 1/8 in. inside the line to allow for some play and a much tighter fit around the base of the obstacle. Apply the wrap as usual. You should now be able to slide over the obstacles with no tension or glue lines. This helps vinyl longevity and appearance. Trim off excess vinyl around the base, but do not cut the on surface. Use the bottom side of the obstacle to trim off excess vinyl. Notice, no glue lines or stress around the edges. Using templates in certain situations will help speed up installation time as well as improve the overall quality. You can even make paper copies and label them for future use. 40 SIGNS OF THE TIMES AUGUST 2020