PW LADDER TRAY COVER CONNECTOR CLIPS T For use with indoor, horizontal covers. Flange-in clip requires tray with 1" side rail flanges. Flange-out clip works with any H-Binder side rail flange width. SoldStrip individually. FLANGE-IN CLIP H-BINDER COVER JOINT STRIP A Closes gaps at cover joints. Notched for the tray side rail. No fasteners required. FLANGE-OUT CLIP H-Binder Strip Abutting Covers Abutting Covers DESCRIPTION PRODUCT NUMBER FASTENER INCLUDED FLANGE-IN FLANGE-OUT 1410 1853* S6 DESCRIPTION PRODUCT NUMBER FLAT COVER CLIP PEAKED COVER CLIP 0925 0926 CATALOG NUMBERING EXAMPLE (EA.): *1853 is Connector System No.† † CATALOG NUMBERING EXAMPLE (EA.): Material Width A2O - 0925 -06 Fasteners T - 1410 -S6 AI and A2O are the only two Connector Splices AI is RAISED COVER CONNECTOR M T For use with all covers, indoors and outdoors. Covers are attached to uprightmounted "C" channel on the top of the cable tray. Install 36"-48" on center. G* RAISED COVER CONNECTOR Raised cover connectors allow for ventilation of ladder tray installations while protecting cables from possible falling objects. Raised cover connectors allow a gap of 1", 2", 3" or 4". Flat or Peaked Cover with Flanges APPLICATION Gap PRODUCT NUMBER 1441 1442 1443 1444 FASTENER OPTIONS ZN S6 PRODUCT NUMBER FASTENER INCLUDED 1432 S6 CATALOG NUMBERING EXAMPLE (EA.): Material Fasteners M - 1432 -S6 CATALOG NUMBERING EXAMPLE: Fitting System No. Width Fasteners 6T2O - 1441 - 06 - S6 RAIL HEIGHTS (H) INCHES 4 5 6 7 For detailed material and finish descriptions, see page B.6. CONNECTORS/SPLICES - Necessary connectors and fasteners are supplied with each section per the below chart. Extra connectors for field cuts or unusual requirements must be ordered separately. Elbows, Reducers 1 pair ea. Tees, Wye 2 pairs ea. Crosses 3 pairs ea. WWW.LEGRAND.US/CABLOFIL METALLIC COVER ACCESSORIES GAP DIMENSION (IN.) 1 2 3 4 A M T B.53http://WWW.LEGRAND.US/CABLOFIL