PW LADDER TRAY Figure 3 Gap Setting Locking hex nuts and flat washers in slotted holes Figure 2 Expansion Connector Installation Locations See Table 1 for Spacing of Expansion Splice Plates Cable Tray Support Flanged hex nuts in round holes Cable Tray Support with withbeHold Down Clamp Expansion splice plates should placed on the outside of the cable tray Expansion Guide Clamp on both side rails. The screw heads should be on the inside and nuts on the outside of the cable tray. Tighten the lock nuts on the screws in the slotted holes just a few turns, allowing the bolt to move freely in the slot. Expansion Splice Plates (Bonding Jumpers Required) Install bonding jumpers Gap Setting across expansion plates Place cable Figure 2 tray supports within 24" of each side of Expansion Connector Installation Locations Expansion Splice Plates Expansion Guide Locations See Table for Spacing Install expansion guide clamps at all1tray Expansion Splice Plates support points other thanofthe midpoint. Cable Tray Support with Hold Down Clamp Cable Tray Section Expansion Splice Plates (Bonding Jumpers Required) Hold Down Clamp Locations Anchor the tray with hold down clamps at the one support point that is nearest the midpoint between expansion gaps. Flanged hex nuts in round holes Cable Tray Support with Expansion Guide Clamp Place cable tray supports within 24" of each side of Expansion Splice Plates Expansion Guide Locations Install expansion guide clamps at all tray support points other than the midpoint. INTRODUCTION B.9 WWW.LEGRAND.US/CABLOFILhttp://WWW.LEGRAND.US/CABLOFIL