BURS LAB CARBIDES LABORATORY CARBIDE BURS "Non-Clogging" for Handpiece * For trimming, carving, and finishing of acrylic, dentures, and chrome-cobalt cases * Not shown actual size All with 3/32" HP Shank Regular Cut...Ea. 16.79 6 @ 15.79 Regular Cut ....Ea. 11.49 6 @ 10.99 BARREL CONE TAPER EGG FLAME INVERTED CONE CYLINDER FLAME PEAR ROUND SIZE 88A 82T 52C 84T 61A 83E 73C 51A 53A 52D REG. CUT 100-0860 100-9194 100-3349 100-9680 100-6866 100-9310 100-6021 100-7866 100-2154 100-0676 SIZE 63B SE-53 54D 41P 44C REG. CUT 101-1966 101-9574 101-2194 101-2733 101-2752 SMALL INV. CONE TAPER FISSURE 71G 31P 100-1889 100-8571 FISSURE 32P 100-7324 DIAMOND CUT LABORATORY CARBIDE BURS All with 3/32" HP Shank Fine diamond-shaped fluting designed specifically to ensure smooth, rapid, clean cutting of ceramic-type gold castings. Ea. 11.79 5 @ 11.29 LATHE LABORATORY CARBIDE BURS ⁄4" Shaft SIZE D1 D4 D5 D6 D7 D8 HP 100-2748 100-3443 100-7351 100-4316 100-4661 100-5955 BEFORE YOU ORDER: This type of carbide bur has a 1⁄4" shaft that is for use in a lathe unit only. It is NOT intended for use in a dental handpiece. 1 (3⁄8" Head) Regular Cut Ea. 27.49 TAPER 66 CONE FLAME EGG (1⁄2" Head) Regular Cut TAPER CONE FLAME Ea. 35.99 EGG For trimming lingual and palatal surfaces Ea. 10.99 CYLINDER SIZE A 3⁄8 B 3⁄8 C 3⁄8 D 3⁄8 A 1⁄2 B 1⁄2 C 1⁄2 D 1⁄2 E 1⁄2 88-T-41⁄4 REG. CUT 100-2741 100-7853 100-6051 100-9616 100-8737 100-5035 100-9290 100-0656 100-6665 101-4080 www.henryscheindental.comhttp://www.henryscheindental.com