USITT SCENIC DESIGN AND TECHNICAL PRODUCTION GRAPHIC STANDARD 5.6.3 upper case letters should be used on drawings unless lower case letters are needed to conform with other established standards or nomenclature. Hand lettering should be generally similar to the mechanically generated characters of fig. 6.1 while acknowledging indil'idual stylistic difference . SflFFENING BATIE '. See fig. 5.6.3 5.7.1 ROTO LOCK. See fig. 5.. 1 5.7.2 PICTIJRE HOOK AND SOCKET. ee fig. 5..2 6.0 MISCELLANEO S. 6.1 LETTERING. 6.2 Lettering should be legible and the style should allow for easy and rapid execution. Characters which generally conform to the single stroke Gothic style meet these requirements. Only 6.2.1 TITLE BLOCK. LOCATION. The title block should be in the sanle location on all drawings of a single project. The title block should be located in either the lower right hand corner of the drawing or in a strip along the bottom of the drall'ing. 6.2.2 FORMAT. Internal title block dil'ision and placement of infornlation is generally unique to the produang organization and is not specified as a pan of these recommendations. APPROVED BY USITf BOARD OF DIRECTORS DALLAS, TEXAS 21 OVEMBER 1992 6.2.3 CONTENTS. Regardless of form the follollwg information should be included: I. ~ame of producing organization. 2. Name of production act and cene, if appropriate. 3. Drall'ing title. 4. Drall'ing number. 5. Predominant scale of the dralling. 6. Date the drall'ing was drafted. . Designer of the production. 8. Drafter if different from the designer. 9. Drall'ing approval if applicable.